NPI specializes in the design and production of custom controllers for your machines. We handle the complete chain,
from schematic design, component selection, PCB assembly, to writing software for the microcontroller and/or PC.
We can handle both one-off's and small series of a few hundred devices on our state of the art production line.
NPI Engineering believes that you should own what you pay for, this means that we will release all designs to you under an open source license after completing the project.
Before we start a project with you, we firstly ask for some general information of your product or machine.
If we can offer you a suitable solution, we will plan a meeting to discuss the specifics of the project and translate your wishes into technical requirements.
After this second meeting, we will make a tailor-made offer and deliverables contract. At the end of the project we will help install the control board
and make sure all involved parties are satisfied with the result.
PCB Design
Every project NPI does is specifically made to meet your requirements, this implies that we design a pcb that uses components
that both meet your requirments and are available in the current supply contraint market.
NPI specializes in the design of boards that control several actuators in your system based on either timing or sensor feedback.
By designing both the circuit boards and the software that runs on them, NPI Engineering is capable to design efficient systems
that both fit your needs and can be assembled in today's supply constrained market.
Embedded Software
Control electronics cannot function without accompanying control software. NPI Engineering tightly integrates both the design of the electronics
and the software needed to control it, which enables us to build integrated systems with minimum overhead.
Whether a system needs to run autonomously, controlled by a control panel or remotely by a laptop,
NPI Engineering will be able to come up with a solution to your specific problem.
NPI Engineering believes that you should own what you pay for, this means that we will release all software to you under an open source license after completing the project.
No need to pay fees to use what you already paid for.
